Q1) Using packet tracer, build the following network topology, and follow the

requirements below:

Using packet tracer, build the following network topology,Cable the network as shown in the topology.

1. Cable the network as shown in the topology. (1 Mark)

2. Cable the network as Configure PC hosts and configure basic settings for each connecting devices.(4 Mark)

3. Configure OSPF routing protocol. 

4. Verify connectivity. 

5. Define Inside and outside interfaces on R2. 

6. On R2, configure one statement for ACL 1 to permit any address belonging to 172.16.0.0/16. 

7. Associate the source list with the outside interface (S 0/0/1 on R2) that obtained its IP

address from the DHCP service configured on the ISP router. 

8. Write the command to test the PAT configuration. 

GET THIS ASSIGNMENT DONE FOR YOU NOW

Network Pack Tracer
Order Now on customessaymasters.com